Port amuellisCan I have a wooden floor on the tilesDifferent play different roles / viewnews11759

category：Environmental protection / date：2023-11-09 09:49:16 / browse：88 / comment：4

In fact, it is very simple to prevent wood floor cracking. Usually, do a good job in floor maintenance and humidification of wood floor in areas with low average moisture content which can be effectively prevented, or raise flowers and fish at home and put buckets in the corner of the room.Generally speaking, most of the strengthened solid wood composite floors are up to standard commodities within the scope of standardized formaldehyde emission.According to relevant requirements, the formaldehyde emission of commodities in the room shall be class E, i.e. ≤ mg/l.Common cost methods for solid wood flooring are as follows:Port amuellis, Simple installation and convenient construction: no wooden keel, no waterproof treatment on the ground, no complex construction process, saving installation time and cost. Smell: whether the product has a chemical smell that irritates people. The big smell is likely to be that the limit of harmful substances exceeds the standard or the printing layer on the surface of floor leather releases toxic gas.Gualan,The current woodworking is basically done by woodworkers. The 'general woodworking' method is adopted, and the shrinkage joint size is not calculated according to the thermal expansion and cold contraction parameters provided by SPC flooring factory.If the room is slightly larger, but the reserved gap is too small, especially when the temperature difference between winter and summer is too large, resulting in arching and warping. High cost performanceIn case of large-scale immersion or partial long-term immersion in water accidentally, if there is any leveling stay, it shall be immediately sucked away with a dry rag and allowed to be dry. It is forbidden to use an electric water heater to carry out dry or expose to the sun.

： I can smell faint wood fragrance. This floor shows that the glue content is very low.Up to European standard E level.Second, mild to moderate scratches. All standard SPC floors must be certified by IS international quality management system and ISO international green environmental protection product certification.Sincere service,Color film layer: various decorative layers of wood grain, stone grain and carpet grain,Port amuellisHome decoration wood floor, which can meet the different needs of different occasions and different tastes.The European solid wood composite flooring market showed a slight downward trend in the third quarter of and is still recovering in In the first quarter, only Denmark completed a slight improvement.China&#;s three-layer solid wood composite floor has a good export market under the overall downturn of the international market.More than % of Jilin&#;s materials are exported, how to build roads and how to check are the problems concerned by interior decorators.Recently, it has been found that wood flooring is gradually popular with large capacity, and customers attach great importance to quality.Nowadays, large and medium-sized flooring has the trend of replacing small and medium-sized flooring.Solid wood flooring materials are not enough, and large and medium-sized composite flooring has gradually become a new pet for home decoration.However, it must be noted that some floors are made of fake and shoddy raw materials, so I should pay attention to corner material floors when purchasing floors. Call a deer a horse: the commercial family pretends that the low-priced tree species are high-priced tree species, Look at the surface of the board.Although there are millions of wood species, there are not many suitable wood for flooring.According to GB / t national standard for solid wood flooring, the national standard for solid wood flooring in China is coniferous wood with air dry density not less than .g/cm and broad-leaved wood with air dry density not less than .g/cm The main applicable wood species under this standard are oak (oak)(there are different opinions about oak. The store will say the same. On the Internet, some say oak, some say oak, but some say oak), birch, two winged bean, muscarine, round bean, teak, ash (Fraxinus mandshurica), iron sapphire, etc. if it exceeds this range, it should be carefully considered, otherwise the quality is not good or the price is unbearable.We hope these techniques will help simplify the plan for installing new floors.If you plan to renovate your house and add new floor elements, please provide room sizes free of charge!Obtain expert estimates to understand how many floors are needed to better determine the project budget.SPC floor is composed of thickened wear-resistant layer, UV layer, color film texture layer and substrate layer.European and American countries call this kind of floor RVP (rigid vinyl plate), rigid plastic floor.The base material is a composite plate made of stone powder and thermoplastic polymer materials after mixing evenly and then extruded at high temperature. At the same time, it has the properties and characteristics of wood and plastics to ensure the strength and toughness of the floor.Wear resistant layer: PVC transparent wear-resistant layer, with a thickness of about .mm, transparent texture, strong adhesion wear resistance and scratch resistance, and the wear-resistant coefficient can reach - revolutions.[]Port amuellis,Port amuellisSpecifications and dimensions of wood floor,Port amuellisWooden floor on tile floor,durabilityFirst, pay attention to the size of the board and try to choose a wide board with a length of cm, a width of -cm and a thickness of cm, or a standard board with a width of cm and a thickness of cm.Waterproof: apply waterproof resin or other waterproof materials at the tongue and groove of the laminate floor, so that the moisture and moisture outside the floor are not easy to invade and the formaldehyde inside is not easy to release, so that the environmental protection and service life of the floor are significantly improved;Especially when laying in a large area, it is inconvenient to leave expansion joints and compression strips, it can prevent floor arching and reduce floor contraction joints.