TrinidadVertical heavy-duty slurry pumpLarge factory quality / news_6452

category：Machinery and industry equipment / date：2023-03-20 00:49:36 / browse：131 / comment：3

　　In fact, and the action time when opening and closing is relatively short.　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. asTrinidad,　　 No leakage protector is installed: leakage protector is also known as lifesaver. If the leakage value of the submersible sewage pump is higher than the working current value of the leakage preventer the leakage preventer will cut off the power supply of the submersible pump to ensure the normal operation of the equipment.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.Newcastle on Tyne,　　The balance ring is also disassembled; Then remove the last stage impeller and the key back, and the middle section including the guide vane; in addition, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurry　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller

　　 Precautions for disassembly of submersible slurry pump Before disassembling the filter press, make sure that the liquid in the submersible slurry pump is completely discharged. If the rotor is disassembled, drain the lubricating oil in the rotor bearing housing. If the newly added oil is stored, check the corrosion of the pump,TrinidadSubmersible sewage pump, remove the rust and paint. If the submersible pump is not used for a long time, it should be carefully checked and put dry.　　Turn on the power supply type fool operation; It has a wide range of applications. In many cases, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.details,　　Many users, including new practitioners of slurry pumps, often fail to distinguish the difference between submerged vertical slurry pumps and submerged slurry pumps. The names of submerged and submerged slurry pumps seem similar, but there are essential differences. What is the difference between submersible slurry pump and vertical slurry pump?　　 Selection of pipeline diameter: the selection of pipeline shall consider the one-time purchase cost,TrinidadIrrigation deep well pump, long-term operation cost and operation reliability.　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.

　　Promote the continuous expansion of the sales network group.Recommendation and consultation,　　Submersible slurry pump can be widely used in mining, power, metallurgy, coal,TrinidadISG single stage vertical pipeline pump, environmental protection and other industries to transport abrasive slurry containing solid particles. Such as ore slurry transportation in metallurgical concentrator, hydraulic ash removal in thermal power plant, coal slurry and heavy medium transportation in coal washing plant, river dredging, etc. In chemical industry　　In order to improve the service life of the submersible sewage pump, most domestic and foreign manufacturers are now trying to find a way on the pump protection system, that is, in case of leakage, overload over temperature and other faults of the pump, it can give an automatic alarm and automatically shut down for maintenance. However, we believe that in the submersible sewage pump　　Commodity.Trinidad,　　Pump, sewage submersible pump and seawater submersible pump.　　Second, the service life of the flow passage parts of the pump is relatively long