category：Building materials / date：2024-04-21 03:36:43 / browse：49 / comment：6
On November , the market price of Cangzhou copper bar was stable. According to the monitoring data of Lange Iron and Steel s cloud business platform, the market price of * mm cold drawn steel produced in Linyi is yuan, the market price of * mm in Linyi is yuan, the market price of * mm in Jianlong is yuan the market price of * mm in Yuanhua is yuan, the market price of * mm in Juneng is yuan, the market price of * mm in Baotou Steel is yuan, and the market price of * mm in Juneng thermal expansion is yuan.[] Welding process of copper pipe Clean the end and seven ports of steel pipe with steel wool. Do not use abrasive cloth or abrasive paper to clean, because it will affect the clean interface and result in poor welding effect.Matt Sarka,Finished products must be stored indoors. During storage, they should be protected from direct sunlight to the copper tubes. During the transfer, transportation and loading and unloading of copper tubes, rain should be avoided; In summer, the ambient temperature of copper pipe is high, and the speed of copper pipe surface is accelerated. When storing copper pipe, pay attention to the principle of first in first out to reduce no loss; The copper pipe loading process is better carried out indoors to avoid the copper pipe being exposed to the sun, so as to accelerate the speed of the outer wall of the copper pipe. After the loading is completed, at least two layers of canvas shall be used to tightly wrap the whole vehicle materials; After loading, if the truck can not depart in time, the truck shall be driven to the back of the sun to prevent the goods from being exposed to the sun for a long time to absorb heat.In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.Salo,After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately, so that dust and dirt will not pollute the capillary gap.Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, the welding flux must have a degree of corrosivity, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.Tangshan billets rose sharply last weekend, steel mills in some northern cities implemented production restriction, and some domestic economic data improved, which boosted manufacturers confidence. Today, steel prices generally rose. However, with the approaching meeting and the rainfall in the south caused by the typhoon the construction progress of the downstream construction site is affected,Matt SarkaAluminum row of cold storage, which is not conducive to the continuous demand. The high spot price transaction today is weak which is difficult to support the continuous rise of steel prices. It is expected that the building materials market will maintain a volatile trend tomorrow, and some businesses may reduce prices and take goods.
In August, the price of domestic medium and heavy plates fell sharply. As of August , the price center of ordinary carbon boards in leading cities had dropped to , down yuan/ton from the end of July. At the beginning of the month, affected by the macro bad news, and the recent poor performance of fundamentals, the market mentality turned to pessimism, and some traders shipped at low prices. The market inventory rose, the inventory pressure was high, the stock shortage phenomenon disappeared, the demand performance continued to decline, continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel, coking, electric power, cement, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan,Matt Sarka321 stainless steel coiled plate, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot; the recent performance of coke is weak. Therefore, in terms of steel plant production,The material of the water separator is the same, the expansion coefficient is the same, and the connection with the water separator is not easy to leak. Scope of application: As the copper pipe is more expensive than the plastic pipe, the cost of the floor heating system is higher.In the morning trading today, down yuan from yesterday. Futures prices fluctuated the average price of * mm hot rolled strip in key cities in China is , and the prices of spot market manufacturers eased slightly today. According to the feedback the market was mainlysee yesterday, which caused the overall transaction blocked,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.
Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.how,Matt SarkaTinned copper bar,If you want to avoid this kind of situation for a long time, you can choose passivation treatment. In this way, not only is the copper surface serious, it can be cleaned under normal circumstances, but it is not a big problem to keep it in the air for one year or more after ultrasonic treatment and immersion treatment, so this effect is very good.Try to avoid using radiator copper pipes in hot water circulation pipelines to reduce the possibility of corrosion. If copper pipes are used as circulation pipelines, especially other acid materials and alkali materials, in the warehouse to prevent mutual reaction.Matt Sarka,In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.The copper bar market declined steadily this week, with a decline of - yuan. Due to low pig iron inventory, some steel mills in Jiangxi have resumed purchasing recently, but the purchasing volume is not large. The purchase price of pig iron in Yunnan steel plants was slightly increased to ensure the purchase volume due to the low purchase price of pig iron in the early stage. Recently, the steel market has been in shock and adjustment, and the merchants are unstable. Steel mills in Hebei, Tianjin and other regions have stopped producing pig iron for steelmaking. Now, it is mainly expected to make inquiries. However, due to the lower price of raw materials, the price of iron mills has been lowered.In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.
share 6 Comments
Comment / Cancel reply