GizaISG single stage vertical pipeline pumpOn the market competition situation of / blog6400

category：Machinery and industry equipment / date：2023-03-18 03:28:40 / browse：138 / comment：3

　　Start the priming pump. Moreover, due to the structural limitations of the submersible slurry pump, the motor needs to be placed on the water surface for use during operation,GizaSubmersible non clogging slurry pump, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must be　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way, we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment andGiza,　　The microcomputer controller displays E: cause: the pressure gauge is disconnected (f= or the input signal is

　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall be　　 When the slurry pump operates, it rotates at a high speed, and the components of the slurry pump have a heavy weight. Therefore, once it reverses,GizaWater well pipeline pump, the force will directly push the impeller to the outside, and the impeller collides with the sheath and guard plate. If the speed is high, the force ratio is low　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.Analysis project　　For example, in the market, for example, the sweeping pump, some of which have a depth of more than meters it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　If there is a standby pump,GizaWQ submersible sewage pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, the water consumption will increase. Therefore, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.Quality inspection report,　　Schematic diagram of vertical slurry pump II. Why does the demand for submersible slurry pump increase greatly? From the perspective of market demand, although the absolute number of submersible slurry pumps has not exceeded that of vertical slurry pumps, mainly due to the convenience and flexibility mentioned above; In addition, for submersible slurry pump　　I would like to talk with you about the problems that should be paid attention to when using deep well pumps.　　Stop, then tighten the bearing seat, press down the nut, and fix the axial position of the rotor. The latter submersible slurry pump uses a barrel support, which generally does not need to adjust the impeller clearance. Therefore, if there is a problem with the clearance in the future use, loosen the support clamp first, and say that the nut is looseGiza, otherwise the effect of the submersible slurry pump may not be obvious.　　 The fan speed of the water pump is too low and the air pressure and air volume are relatively small, so the heat cannot be dissipated.　　Whether it is the pre installation inspection or the post installation commissioning inspection, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.