New YorkShanxiDo you need professionalism? What do you need to pay attention to? / blog19385

category：Machinery and industry equipment / date：2024-03-28 00:22:11 / browse：48 / comment：6

The quality of the standard section should comply with the product manual and specification requirements.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.New York,Safety devices: Electric elevators for construction should be equipped with overload detection devices. When the load inside the cage exceeds % of the rated load capacity, the overload detection device will give a warning signal inside the cage,Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, scissors, wiring and oil cylinder once a week to avoid dust and debris affecting normal operation.Vancayo, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirementsSetting requirements: The landing door should be standardized and tooled.During the use period, and record the inspection results.Setting requirements: The wall bracket should use the manufacturer's matching standard products.

Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentPoleFlat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.recommendThe angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, accurate positioning,New YorkStrasbourg, it can be stopped arbitrarily within the range of travel.Vertical lead screw electric lifting mechanism: Adopting a lead screw transmission method, it can achieve the lifting of a double-layer tabletop. Multiple lifting platforms can be formed as needed, and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Terrace, Tower, Pavilion; Ideal props.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.market,The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, etc.Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures,New YorkAbuquiki,New YorkFrance, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.New York,Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than m. In special circumstances, when the net height of the building entrance is less than m, it is allowed to lower the height of the lower door opening, but in any case, the net height of the lower door opening is not less than m. (Article of GB-)