KatanzaroSelf-propelled lifting platformWhat's the manufacturing technology / article21658

category：Machinery and industry equipment / date：2024-04-29 01:47:00 / browse：36 / comment：5

Check the oil level of the gearbox and make up for new oil if necessaryThe reduction gearbox, gearbox,KatanzaroPrice of guide rail type lifting platform, external meshing gear and other parts, as well as the hydraulic oil, are all carried out according to the requirements in the table.Katanzaro,The vibration frequency should be set to obtain large dynamic stress with low energy consumption, and the resonance frequency should be used to handle time dependent vibration. However, there may be one or more resonance peaks in large components, which slowly increases the speed of the excitation motor from , and determines the relationship curve between the amplitude of the workpiece and the motor speed to determine the resonance point of the workpiece. According to the scanning curve, a large acceleration was obtained at r/min, so r/min was determined as the aging frequency.Monthly maintenance: View weekly inspection itemsTouloua,Check the oil level of the gearbox and make up for new oil if necessaryRegularly check all wires and cables for damage. Timely bandage and replace damaged parts.Check if the orientation of the upper and lower limit blocks on the guide rail frame is correct

Since the antirust paint on the exterior layer will actively react with the oxygen in the air, especially in the cold sun or rainstorm climate, the reaction speed will be accelerated so the exterior paint on the warehouse goods elevator will show signs of aging and then fall off every once in a while. Therefore, when maintaining the equipment of the lift table at ordinary times, pay attention to its storage, and try not to leave it outdoors, let alone in cool days or rainstormThe lifting foundation of the platform is a large structural component made of alloy steel plates with different thicknesses that are welded together. The welding amount is large, the structural shape is complex, and residual stress is inevitably generated during the manufacturing process. In order to prevent deformation of the components due to changes in residual stress during use, it is necessary to perform stress relief treatment on the completed components.Ensure that power cables and electrical circuits are not damagedindex,Check the wear condition of the pinion and rack, please refer to the instruction manual for specific requirementsCheck and repair the electrical circuit and control panel switch components. If there is aging in the circuit,KatanzaroGuide rail type lifting platform Lifting platform,Manganese steel is generally used as the primary profile for warehouse cargo elevators. In order to achieve better anti-corrosion effect, a layer of rust resistant primer is usually applied, which effectively blocks air and prevents premature corrosion of the steel. Below, Ruilong hydraulic press will explain the role of rust resistant primer.The second method is the protective layer method, which covers the metal surface of the aluminum alloy lifting platform with a protective layer to isolate the metal products from the surrounding corrosive medium and prevent corrosion. Apply engine oil petroleum jelly, paint, or cover the surface of steel parts with corrosion-resistant non-metallic materials such as enamel and plastic; It is not easy to apply a layer of electroplating, hot plating, spray plating, etc. on the surface of steelCheck the relative orientation between the cable support wall and the cable guide frameKatanzaro,KatanzaroGuide rail vertical lifting platform, and dismantle the gearbox. Clean all components and seals, replace excessively worn and deformed parts and smooth oilCheck the relative orientation between the cable support wall and the cable guide frameWeekly maintenance: According to the operation instructions, ensure that the elevator is inspected and smooth every day