category:Machinery and industry equipment / date:2023-03-11 07:42:36 / browse:129 / comment:3
Slurry pump Inappropriate model is selected when selecting the pump. In actual use, when the load conditions do not match the model of the slurry pump, for example, the pump lift used is too high or too low which will lead to overload, so we are selecting the pump How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.Minas, Unsuitable pump head is selected. The direction of the differential pressure force is opposite, Troubleshooting: first increase the water pressure, then inject water into the pump body, and then start the pump. At the same time check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found, and tighten the screws. In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines. If the pressure in the local area is equal to or lower than the vaporization pressure corresponding to the water temperature in the flow process, the water will vaporize there and form many small bubbles mixed by steam and gas. The cavitation phenomenon is due to the bubble action when these small bubbles flow from the low-pressure area to the high-pressure area in the water pump,
If the pressure in the local area is equal to or lower than the vaporization pressure corresponding to the water temperature in the flow process, the water will vaporize there and form many small bubbles mixed by steam and gas. The cavitation phenomenon is due to the bubble action when these small bubbles flow from the low-pressure area to the high-pressure area in the water pump, And has a wide range of applications. Assembly of rotor parts of submersible slurry pump Before assembly, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.middleman, For example,MinasPipeline pump body,MinasQuotation slurry pump, in the market, for example, the sweeping pump, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump. Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles. Impeller protection in order to ensure the operation of the submersible slurry pump, it is necessary to timely adjust the clearance between the impeller and the front guard plate. When adjusting the impeller clearance, first stop the pump, loosen the bolts pressing the bearing box, loosen the adjusting nuts, make the bearing components move forward, and roll the shaft by hand to press the
there is also a simple method to measure the vibration frequency of the pump by vibration method. However, when using one method,MinasFire deep well pump, there may be some errors in the measurement results. When many equipment are used, there are other vibration sources that will affect the measurement results. Therefore, in fact, it is mainlyMarketing Department, Third the whole industrial and mining system operates stably, and the operation of the pump will not affect the work of the whole industrial and mining system. Note: Motors for special environment can be customized according to the contract. The utility and durability of the utility model, so the polymer composite materials are generally used in production.Minas, Rate loss, so shaft power = effective power + lost power. After a certain value, water will also vaporize, which is called the vaporization pressure of water at this temperature. Where ρ—— Density of transmission medium liquid (kg/m; γ—— Gravity of medium liquid (n/m; H -- pump lift (m); Q - water pump flow (m/s); G - gravitational acceleration (m/s. The difference between the shaft power P and the effective power PE is the power loss in the pump, which is measured by the pump efficiency. The pump efficiency is the ratio of the effective power and the shaft power, which is measured by η Indicates.
share 3 Comments
Comment / Cancel reply