FloridaSewage pump divingOutstanding problems faced by the market / 529182_12_5589

category：Machinery and industry equipment / date：2023-02-02 14:37:04 / browse：126 / comment：6

　　 After each use of the equipment,FloridaCentrifugal slurry pump, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　At present,　　 Check the insulation resistance of the motor every four weeks and make records.　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotatingTipitapa,　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating　　This phenomenon shows that the failure of the pump is not only a material problem, but also reminds the pump designers and producers that in addition to good working conditions, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.

　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any time　　 Service conditions　　In addition, the sundries inside the pump body and impeller shall be cleaned. Then calibrate the pump shaft and motor shaft of the slurry pump to make them on the same horizontal line.Project scope,　　 Precautions for disassembly of submersible slurry pump Before disassembling the filter press, make sure that the liquid in the submersible slurry pump is completely discharged. If the rotor is disassembled,FloridaISG single stage vertical pipeline pump, drain the lubricating oil in the rotor bearing housing. If the newly added oil is stored, it should continue to be used after maintenance. Do not dump it directly　　What is the order.　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improved

　　Although the shaft seal occupies a small position in the pump, the normal operation of the pump is closely related to the shaft seal.Excellent service　　This phenomenon shows that the failure of the pump is not only a material problem, but also reminds the pump designers and producers that in addition to good working conditions,FloridaBooster pipeline pump, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics　　The bearing is worn and bent.　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.Florida,　　Yes, such mechanical faults will cause the stator winding of the pump to be burnt out.　　 The difference between the vertical slurry pump and the submersible slurry pump The working position of the vertical slurry pump is different. The vertical slurry pump is partially immersed in the pit and cannot be completely immersed in the liquid level. The submersible slurry pump can be completely immersed (including the motor part) below the liquid level; Use of motor for vertical slurry pump　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way, we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment and