category:Machinery and industry equipment / date:2024-04-23 00:04:32 / browse:44 / comment:3
Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped. Pump,ShijakSubmersible sewage pump, Submersible pump: as the name suggests, the whole pump (with motor) needs to be in the slurry. It is an auxiliary means for some on-site monitoring.Kyela, Cavitation of the pump is caused by water evaporation of the pump. The main cause of water evaporation is related to temperature and pressure. Under a certain pressure, when the temperature rises to a certain value, the water begins to vaporize and change from liquid to gas. On the contrary, the pressure drops to In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized. Commodity.
It is longer and saves production cost. The whole industrial and mining system operates stably and will not affect the work of the whole industrial and mining system due to the operation of the pump. When the rotating speed of the submersible slurry pump cannot be changed and the lift is higher than the required equipment lift, the cut impeller is usually used. The cut is Remove the wire guard, water strainer and cut the cable from the lead and the three core cable or flat cable connector. Pump. In addition,ShijakDrilling fluid slurry pump, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing.Executive standard, Whether it is the pre installation inspection or the post installation commissioning inspection,ShijakVertical centrifugal slurry pump, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site. There will be no insufficient liquid supply or other problems. What should be paid attention to in the process? Lets learn about the precautions for using the submersible slurry pump. When the equipment is in use, the pump itself generally needs to be placed on land for use, but its suction pipe needs to be placed in water
If there is abnormal sound inside the slurry pump and there is no water, it is likely that the equipment may have air infiltrating into it when absorbing water, which will cause abnormal sound inside the pump, and then at the same time, the impeller is damaged or the impeller is damagedManufacturing cost, However there is also a disadvantage of using the auxiliary impeller sealing system, it takes some energy on the auxiliary impeller of the submersible slurry pump that is, which is generally about %. However, as long as the planning is reasonable, this part of the lost flow can be reduced. The slurry pump is mainly applicable to electric power, metallurgy and coal The bearing is worn and bent. The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.Shijak, Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing. A large amount of lubricating oil is stored. Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.
share 3 Comments
Comment / Cancel reply