BotouHydraulic lifting loading and unloading platformPrecautions for installation and operation / 391HP142030639_127408

category：Machinery and industry equipment / date：2023-06-04 23:27:48 / browse：120 / comment：6

What are the common faults of the hydraulic lifting platform. The oil cylinder load of the hydraulic lift platform is severe. Unemployment in the internal closed ring is incomplete or internal obstacles can easily cause uneven stress, resulting in uneven height of the oil cylinder. It is recommended to carefully check whether the oil cylinder is normal.If there are problems inside the elevator, and there are electrical professional staff presents, any component of the hydraulic system should be carried out when disassembling any components of the hydraulic system, and maintenance should be carried out under the condition of thoroughly discharge.Botou, Brand awareness. Although there are many brands about mobile lifting platforms,BotouElectric lifting hydraulic platform, not all brands have a very high reputation in the market. When choosing, you can choose as much as possible brands as possible, because this type of product can have a high popularity in the market to show that its advantages in all aspects are strong.Navoi, safety device, buffer spring, etc. before use before use. Make sure it has a safe environment. Brand awareness. Although there are many brands about mobile lifting platforms, not all brands have a very high reputation in the market. When choosing,BotouFour column hydraulic lifting platform, you can choose as much as possible brands as possible, so as to make this type of cargo ladder more good.

Always check whether all wires and cables are damaged.Failure exclusion: When the elevator power supply light is turned on the above process points need attention and grasp when processing the electricity lifting ladder processing, press the lifting button, the motor rotates,BotouSmall hydraulic lifting platform, and the lifting platform does not rise. This may be the reversal of the motor after the three -phase power supply is connected. Just change the two -phase line of the heavy machine.technological innovation,The motor should be parked immediately when the motor is overheated. After the failure, the motor continues to run, and the motor bearing is good.Put all the hydraulic oil in the fuel tank, open the fuel tank, remove the oil absorbing filter, wash it back and put it back to the fuel tank, and install it in situ. The new oil is filled with new oil in the fuel tank.For the introduction of the daily maintenance of the lifting cargo ladder, the brakes of each organization should usually implement the interval between inspection and adjustment of braking tiles and brake wheels, and the management is sensitive and reliable. On the surface, there should be no dirt, and it must be washed off with gasoline or scarcity when encountering dirt.

Failure exclusion: When the elevator power supply light is turned on, press the lifting button, the motor rotates, and the lifting platform does not rise. This may be the reversal of the motor after the three -phase power supply is connected. Just change the two -phase line of the heavy machine.how much,When installing, disassembling, and adjusting exhibitions, we must pay attention to the central line of the central line of the controller of the pipeline and transfer tissue. The meshing surface is not less than %, and the mesh interval should be appropriate.There are foreign bodies inside the hydraulic lifting platform, which causes uneven stress to transport hydraulic oils to cause hydraulic oil. Unemployed countertops will occur. It is recommended to carefully check whether the conveying oil pipe is unblocked.Botou,The size of the oil cylinder, the oil cylinder, will reduce the size of the oil cylinder as much as possible without the design requirements. The smaller the size of the oil cylinder the faster the rising speed.Because the hydraulic lifting platform power unit requires oil sources, and it also has certain pollution and influence on the environment. The movement device is relatively fast. The structure of the electric rod is very simple, and the space occupies is small, but there is no advantage in price, so the power supply will be used as the power source of the lifting machine. The DC motor is directly transmitted to other mechanical devices through the reduction of the reducer.Each institutional brakes should regularly check and adjust the gap between brake tiles and brake wheels to ensure flexibility and reliability. There should be no dirt on the friction surface. If there is dirt, it must be cleaned with gasoline or rare materials.