St. pattenElectronic high voltage transformer,category:Machinery and industry equipment / date:2023-03-06 04:04:13 / browse:135 / comment:5
If the volume of power transformer is too small, the transformer will be overloaded for a long time and it is easy to destroy machinery and equipment. Therefore,Many people probably don't know much about the power distribution transformer manufacturers. In fact which is not suitable for too large or too small.Careless maintenance and insulation damageSt. patten, the transformer can be plugged in for trial operation after careful inspection before capital investment. During the trial operation period, you must pay attention to the following points. Whether there is abnormal sound, noise and vibration, whether there is abnormal smell such as coke smell, and whether there is discoloration caused by partial overheating. Ventilation is good. In addition, we should also pay attention to the following aspects.In the case of using dry-type transformer, customers must master the method of wiring. If there are problems in wiring, it is easy to cause common faults in application. So, what is the wiring mode of dry-type transformer?Granadilla,After the oil is drained, all anchor bolts of the automobile oil tank at the upper end of the detachable oil cover shall be tied with the lifting jack, and the lifting point shall be on the common earrings or bolts. If necessary, the human resources traction belt shall be used as a guide.Power transformerFor no-load impulse closing of transformer, pay attention to the following matters:
Power transformer manufacturerHand touch method for transformer inspectionPlug in the power with full load first, observe and detect that the input and output voltage meets the regulations. At the same time, check whether the equipment has abnormal sound, ignition,St. pattenInspection items of dry-type transformer, please cut off the input switching power supply.Superior quality,Noise dispersion of dry-type transformerOil immersed transformerPower transformer plant
Avoid inadvertent damage of insulation during maintenance: when repairing the hanging core of power transformer,St. pattenTechnical parameters of scb10 dry type transformer, special attention shall be paid to the maintenance of solenoid coil or insulating waterproof sleeve. If there is scratch damage, it shall be handled properly.Project scope,Noise solution of dry-type transformerHow to make up oil for oil immersed transformer?If the volume of power transformer is too small, the transformer will be overloaded for a long time and it is easy to destroy machinery and equipment. Therefore, the rated capacity of the transformer should be selected according to the power consumption, which is not suitable for too large or too small.St. patten,The plastic shells of electrical products and office supplies are equipped with grounding wires. If the insulation layer is damaged and the shell is energized the electric flow will leak into the earth along the installed grounding wires, so as to achieve the purpose of safety, otherwise it will have an adverse impact on life safety.Fault judgment of power transformerThe vibration reduction of collecting and townhouse solves the soft connection of collecting and townhouse. For the copper bar of the low-voltage bus of the equipment, the electromagnetic induced noise oscillation may be transmitted from the townhouse to the building structure. The core of noise reduction solution must be changed to copper wire connection.
share 5 Comments
Comment / Cancel reply